• CN:11-2187/TH
  • ISSN:0577-6686

›› 1999, Vol. 35 ›› Issue (3): 16-19.

• 论文 • 上一篇    下一篇

扫码分享

Al-Si16%合金的过热温度与结晶行为

王伟民;边秀房;秦敬玉;鲁典照;Silusaranko S I   

  1. 山东工业大学材料学院;青岛生建机械厂;乌克兰金属物理所
  • 发布日期:1999-05-01

RELATION OF SUPERHEATING TEMPERATURE AND SOLIDIFICATION IN Al-Si16% ALLOY

Wang Weimin;Bian Xiufang;Qin Jingyu;Lu Dianzhao; Silusaranko S I   

  1. Shandong University of Technology Qingdao Shengjian Machinery Works Institute of Metal Physics, Ukraine National Academy of Science
  • Published:1999-05-01

摘要: 研究了不同过热温度对Al-Si16%结晶组织的影响,发现当过热温度超过900℃后,试样中的初晶硅尺寸与数目大量增加,共晶硅的尺寸变小。DSC分析表明,一定程度的过热增加了Al-Si16%的结晶潜热。液态X射线研究发现,在900℃以下,Al-Si16%的平均配位数比相同温度纯铝低,而在900℃以上,合金的平均配位数要高,1250℃温度过热后,合金熔体在液相线上方就已出现与硅晶态相对应的衍射峰。过热温度对结晶行为的影响可用Al-Si16%熔体中Al-Si原子团在较高过热温度下向Al-Si原子集团转化的机制来解释。

关键词: Al-Si16%, 过热温度, 结晶

Abstract: The effect of superheating on the solidification in Al-Si 16% o alloy is investigated. It is showed that the amount and size of the primary silicon phase increased greatly after superheating of high temperature (>900℃). The latent heat and initial temperature of primary solidification also increased obviously after high temperature superheating (>900℃) by DSC analysis. By the way of X-ray diffractemeter, it is found that the atomic coordination number of Al-Si16% alloy is higher than pure Al at high temperature (> 900℃) and less than pure Al at low temperature (<900℃). The peaks implied solid Si phase appeared on diffraction intensity cure of liquid Al-Si16% alloy after superheating of high temperature while they were absent in the case of low temperature superheating.

Key words: Al-Si16 %, Solidification, Superheating temperature

中图分类号: