• CN：11-2187/TH
  • ISSN：0577-6686
机械工程学报

机械工程学报 ›› 2016, Vol. 52 ›› Issue (20): 159-167.doi: 10.3901/JME.2016.20.159

• 交叉与前沿 • 上一篇    下一篇

扫码分享

进出口独立控制液压挖掘机回转系统运行特性*

黄伟男, 权龙, 黄家海, 杨敬   

  1. 太原理工大学新型传感器与智能控制教育部重点实验室 太原 030024
  • 出版日期:2016-10-20 发布日期:2016-10-20
  • 作者简介:

    黄伟男，男，1989年出生，博士研究生。主要研究方向为工程机械液压系统节能控制。

    E-mail：huangweinan0113@link.tyut.edu.cn

    权龙(通信作者)，男，1959年出生，博士，教授，博士研究生导师。主要研究方向为电液伺服及比例控制技术。

    E-mail：quanlong@tyut.edu.cn

  • 基金资助:
    * 国家自然科学基金(U1510206)、国家科技支撑计划(2014BAF08B06)和山西省科技攻关(20140321008-02)资助项目; 20150817收到初稿，20160726收到修改稿;

Excavator Swing System Controlled with Separate Meter-in and
Meter-out Method

HUANG Weinan, QUAN Long, HUANG Jiahai, YANG Jing   

  1. Key Lab of Advanced Transducers and Intelligent Control System of Ministry of Education，Taiyuan University of Technology， Taiyuan 030024
  • Online:2016-10-20 Published:2016-10-20

PDF

628

摘要：

传统液压挖掘机回转系统是由单自由度的四边联动的多路阀控制，导致其可控性较差，能耗较大。针对这一问题，提出采用泵阀复合、压力流量匹配的进出口独立的回路原理，控制液压挖掘机回转系统，液压马达两腔的压力和流量可以根据不同的工况进行独立调节。建立液压挖掘机回转系统机械结构多体动力学与电液系统联合的数字样机，利用该样机对所提出系统的可行性进行验证，针对回转系统大惯性的特点，分别对启动阶段和制动阶段制定相应的控制策略，仿真结果表明系统运行平稳。在此基础上，进一步构建基于上述原理的试验系统，并与LUDV系统试验结果进行对比，试验结果表明采用泵阀复合进出口独立控制方法能耗降低25.5%~35.6%，阀口压力损失减小50%，显著抑制上车摆动现象。

关键词: 泵阀复合, 进出口独立控制, 流量匹配, 能量效率, 回转系统, ZL205A铝合金, 差异壁厚构件, 等Biot理论, 微变形, 有限元模拟, 准同步淬火

Abstract:

Conventional swing system of hydraulic excavator is controlled by a valve control system with single degree of freedom due to the fact that its inlet and outlet orifices are connected mechanically, as a consequence, it has some disadvantages such as bad controllability and high energy consumption. To solve this problem, a separate meter-in and meter-out hydraulic excavator swing system with pump and valve combined control and flow rate matching is proposed. In this system, the pressure and flow rate of the motor working chambers can be controlled independently according to the working condition. Furthermore, a virtual prototype is developed consisting of the hydraulic excavator mechanical structure with multi-body dynamics and electro-hydraulic system for analyzing the feasibility of this swing system, and the simulation result demonstrates that this system works smoothly. After using the presented control strategies, compared with the LUDV system, the result of the experiment shows that a reduced energy consumption of up to 25.5%-35.6% for the swing drive is achieved, the system can reduce the throttle loss 50% and suppress the swing vibration obviously.

Key words: energy efficiency, flow rate matching, pump and valve combined control, separate meter-in and meter-out, swing system

版权所有 © 2019 《机械工程学报》编辑部 | 京ICP备05055788号-30