• CN:11-2187/TH
  • ISSN:0577-6686

›› 2002, Vol. 38 ›› Issue (6): 106-110.

• 论文 • 上一篇    下一篇

新型小直径端面CBN砂轮开发及其磨削性能研究

阎秋生;张自强;庄司克雄;田中宪司   

  1. 汕头大学机电系;日本东北大学
  • 发布日期:2002-06-15

DEVELOPMENT OF NEW TYPE CUP CBN QUILL AND STUDY ON ITS FACE GRINDING PERFORMANCE

Yan Qiusheng;Zhang Ziqiang;Syoji K;Tanaka K   

  1. Shantou University Tohoku University
  • Published:2002-06-15

摘要: 基于电镀小直径端面CBN砂轮磨削沟槽的试验结果,为减小沟槽底面与侧面过渡圆弧半径,开发了一种新型小直径端面CBN砂轮,在试验研究其磨削性能的基础上提出了改善措施,取得了良好的磨削效果。新型端面CBN砂轮加工沟槽的过渡圆弧半径达到0.2 mm以下,比电镀CBN砂轮减小60%以上。新型端面CBN砂轮磨削过程中,由于有效CBN磨粒发生的后面磨损及其破碎,使磨粒切削刃凸出高度降低,而砂轮表面所有CBN磨粒均先后依次成为有效磨粒,因此提高单个CBN磨粒的耐磨性和韧性,减小破碎,是提高新型CBN砂轮寿命的有效措施。选用多晶强韧的CBN磨粒(通用电器GE550型产品)使砂轮寿命提高到了原来的6.75倍。

关键词: CBN砂轮轴, 端面磨削, 过渡圆弧半径, 结合剂, 磨削力

Abstract: Based on the experimental results of grinding groove bottom using electroplated CBN cup quill, a new type cup CBN quill is developed in order to reduce corner radius between groove bottom and flank. According to experimental study on its grinding performance, improving measures are presented, and a good grinding result is obtained. As a result, the corner radius of new type cup CBN quill is less than 0.2 mm and remarkably less than one of electroplated cup CBN quill, the reduced factor is over 60%. It is discovered that flank wear on the effect CBN grain and subsequently the break of the CBN grain in the grinding process make reducing the protrusion height of effect grains, and all of the CBN grains on wheel surface become effect grains successively. Therefore, improving the wearability of CBN grain and heightening the toughness of CBN grain to reduce the break are effect measures to increase life of new type CBN quill. High-toughness polycrystalline CBN grains (GE 550 type) are chosen, it makes the life of new type CBN quill be increased by a factor of 6.75.

Key words: Corner radius, Bond, CBN quill, Face grinding, Grinding force

中图分类号: