在钢料薄切削层车削下的加工表面光洁度

›› 1965, Vol. 13 ›› Issue (4): 93-105.

在钢料薄切削层车削下的加工表面光洁度

陈日曜等

华中工学院

发布日期:1965-09-01

THE SURFACE-FINISH OBTAINED UNDER EXTRA-FINE FINISHING METAL-CUTTING PROCESS

Chen Yehyaw

Contral-china institute of Technology

Published:1965-09-01

摘要/Abstract

摘要： 在半精加工及精加工钢料时切削厚度常小于0.05毫米以至接近于5微米（μ），其时加工光洁度一般要求较高。由于此时切削厚度较薄，加工光洁度与刀刃参数如刀刃不平度、楔角及刀刃圆半径等有着较密切的关系，而所用冷却润滑液及切削过程中所产生的积屑瘤也对加工光洁度起着一定的影响。鉴于这一问题在过去文献中尚缺乏系统的参考资料，本文报导了我们在车床上进行的比较系统的试验，目的在于使所得的结果可供生产上用点接触刀具加工中碳钢料时的参考与比较。

Abstract: This paper presents the experimental results & investigations of authors on the influences of the surface-finish -& the tool-lip parameters of the metalcutting tools, the cutting fluid & the built-up edge on the obtained surface-finish of the work of medium carbon steel under extra-fine finishing metal-cutting process. The solution of this problem is beneficial for the selection of the reasonable surface-finish & the reasonable tool-lip parameters of the metalcutting. Tool in the finishing & semi-finishing operations of metal-cutting process.

陈日曜等. 在钢料薄切削层车削下的加工表面光洁度[J]. , 1965, 13(4): 93-105.

Chen Yehyaw. THE SURFACE-FINISH OBTAINED UNDER EXTRA-FINE FINISHING METAL-CUTTING PROCESS[J]. , 1965, 13(4): 93-105.