• CN:11-2187/TH
  • ISSN:0577-6686

机械工程学报 ›› 2017, Vol. 53 ›› Issue (24): 135-143.doi: 10.3901/JME.2017.24.135

• 运载工程 • 上一篇    下一篇

基于多源信息融合的行驶工况识别及其在整车转矩分配中的应用

张袅娜1,2, 郭孔辉2, 丁海涛2   

  1. 1. 长春工业大学汽车工程研究院 长春 130012;
    2. 吉林大学仿真与控制国家重点实验室 长春 130022
  • 收稿日期:2016-11-24 修回日期:2017-09-20 发布日期:2017-12-20
  • 作者简介:张袅娜,女,1972年出生,教授,博士,博士研究生导师。主要研究方向为复杂系统控制、电动汽车驱动理论及控制。E-mail:zhangniaona@163.com
  • 基金资助:
    国家重点基础研究发展计划(973计划,2011CB711205)和国家自然科学基金(61603060)资助项目。

Driving Cycle Recognition Algorithm Based on Multi-source Information Fusion and Application in Vehicle Torque Distribution

ZHANG Niaona1,2, GUO Konghui2, DING Haitao2   

  1. 1. Automotive Engineering Research Institute, Changchun University of Technology, Changchun 130012;
    2. State Key Laboratory of Automotive Simulation and Control, Jilin University, Changchun 130022
  • Received:2016-11-24 Revised:2017-09-20 Published:2017-12-20

摘要: 传统的行驶工况判别方法多采用单参数或者双参数进行判别,为提高工况识别精度,针对混合动力汽车双动力源的特点,提出一种多源信息融合的汽车行驶工况识别方法,基于Daubechies小波对多传感器采集到的时间序列进行分解,利用单支小波重构的方法获得每个传感器不同频段下分解信号的数据特征信息,然后基于变属性权重的模糊C-均值聚类方法将不同传感器不同频段的数据特征信息进行一次聚类识别;最后对不同频段下同一工况的隶属度值加权,采用SOM自组织映射网络进行二次聚类融合实现最终的行驶工况识别。将本文所提方法应用于混合动力汽车整车转矩分配中,不同工况下调用不同的转矩分配三层前馈神经网络模型,以提高整车的经济性能。试验结果验证了本文所提方法的有效性。

关键词: Daubechies小波, SOM网络, 工况, 聚类, 模糊C均值, 信息融合

Abstract: Single or double parameters are adopted in traditional discriminant methods of running condition to distinguish the working condition. In order to improve the identification accuracy, a multi-source information fusion of the motor running condition recognition method is proposed, which aims at the double power sources characteristic of the hybrid cars. The data characteristic information of the decomposed signal in different frequency bands of each sensor is obtained by using single wavelet reconstruction method, so that feature information of different frequencies for each sensor data are obtained. Then different frequencies data feature information from different sensors are conducted by a clustering recognition based on variable weight fuzzy C-average clustering method. Finally, the membership values under different frequencies, belonging to a particular category, are obtained. The final running condition recognition is conducted by the SOM self-organizing map network secondary clustering fusion. In order to improve the vehicle's economy target,the proposed method is applied to torque distribution control of hybrid electric vehicle, and a three-layer feedforward neural network model with different driving conditions with different torque distribution neural network model was assigned. The experimental results verified the effectiveness of the proposed method.

Key words: clustering, Daubechies wavelet, driving cycle, fuzzy c-means, information fusion, SOM network

中图分类号: