基于Sola算法强迫层流纯物质枝晶生长相场法模拟

›› 2010, Vol. 46 ›› Issue (14): 60-67.

扫码分享

基于Sola算法强迫层流纯物质枝晶生长相场法模拟

王智平;王军伟;朱昌盛;冯力;肖荣振

兰州理工大学甘肃省有色金属新材料省部共建国家重点实验室;甘肃省有色金属及复合材料工程研究中心;兰州理工大学CAD中心

发布日期:2010-07-20

Phase-field Simulation of Pure Material Dendritic Growth Based on Sola Algorithm in Force Laminar Flow

WANG Zhiping;WANG Junwei;ZHU Changsheng;FENG Li;XIAO Rongzhen

State Key Laboratory of Gansu Advanced Non-ferrous Metal Materials, Lanzhou University of Technology Research Center of Gansu Non-ferrous Metal Materials and Composite Materials Engineering CAD Center, Lanzhou University of Technology

Published:2010-07-20

摘要/Abstract

摘要： 采用SIMPLE算法耦合流场的相场法模拟过冷熔体枝晶生长过程计算效率较低。将计算效率较高的自适应压力迭代法修正的Sola算法与相场模型结合，建立模拟过冷熔体在强迫层流状态下枝晶生长的Sola-相场模型(Sola-phase field model, S-PFM)，实现过冷熔体流动场与相场的完全耦合，基于该模型模拟高纯丁二腈(SCN)过冷熔体枝晶生长行为。结果表明，过冷熔体在层流状态下，迎流方向枝晶尖端生长速度大于无流动时候的枝晶尖端生长速度，而下游枝晶尖端生长速度小于无流动时候的枝晶尖端生长速度，它与TONG等采用结合SIMPLE算法的相场模型模拟结果一致；并且，流动法向枝晶尖端在其逆流侧出现漩涡初期生长速度不稳定；同时，过冷熔体层流速度越大，迎流方向枝晶尖端生长速度越大，固相率也越高。

关键词: Sola算法, 层流, 计算机模拟, 枝晶生长

Abstract: Computation efficiency is not high in simulating dendritic growth by combining the SIMPLE algorithm with the phase field method. However, efficient Sola-phase field model (S-PFM) for complete coupling of phase field with flow field of undercooled melt is established to simulate the dendritic growth of udercooled melt in a forced laminar flow state. The model combines the phase field method with the Sola algorithm corrected by adaptive iteration scheme. Based on this model, the dendritic growth behavior of undercooled melt of high purity succinonitrile (SCN) is simulated. The results show that when the undercooled melt is in laminar flow state, the growth velocity of upstream dendritic tip is higher than that when the melt is without flow, but the growth velocity of downstream dendritic tip is lower than that when the melt is without flow. The results agree with the simulation results obtained by TONG and other phase field models which combine with SIMPLE algorithm. Moreover, growth velocity of dendritic tip normal to flow is not stable at the early stage of emergence of eddy current. Besides, the higher the laminar flow rate of undercooled melt is, the higher the growth velocity of upstream dendritic tip and the solid phase ratio will be.

Key words: Computer simulation, Dendritic growth, Laminar flow, Sola algorithm

中图分类号:

TG244 TG248

王智平;王军伟;朱昌盛;冯力;肖荣振. 基于Sola算法强迫层流纯物质枝晶生长相场法模拟[J]. , 2010, 46(14): 60-67.

WANG Zhiping;WANG Junwei;ZHU Changsheng;FENG Li;XIAO Rongzhen. Phase-field Simulation of Pure Material Dendritic Growth Based on Sola Algorithm in Force Laminar Flow[J]. , 2010, 46(14): 60-67.

[1]	杨欢, 伊鹏辉, 覃锴, 黄典贵. 基于钝尾缘翼型叶片的三维风力机性能分析[J]. 机械工程学报, 2023, 59(6): 123-130.
[2]	刘海龙, 吴洪雷, 曹宇, 孙靖晨, 毛保东, 王军锋. 变转速耦合偏心结构实现高效层流混合的荧光可视化试验研究[J]. 机械工程学报, 2021, 57(8): 240-246,254.
[3]	赵波. 初始制动时预测湿式制动器热对流特性的积分方法[J]. 机械工程学报, 2020, 56(24): 198-207.
[4]	梁瑛娜, 高殿荣, 拜亮. 双层桨搅拌槽内层流流场与混合时间的数值模拟[J]. 机械工程学报, 2015, 51(16): 185-195.
[5]	黄延平. 电器空气冷却系统受海拔影响的理论分析[J]. 机械工程学报, 2015, 51(12): 153-160.
[6]	史传伟;邹勇;邹增大;赵伟. 双钨极间接气体保护焊接电弧的数值模拟[J]. , 2013, 49(22): 97-102.
[7]	杨肖;张志辉;王金田;张宝玉;王亮;常芳;任露泉. 仿生制动盘表面温度场与应力场的计算机模拟[J]. , 2012, 48(17): 121-127.
[8]	宋满仓;刘莹;祝铁丽;张传赞;刘军山;刘冲. 微流控芯片注塑成型缺陷的成因与对策[J]. , 2011, 47(6): 33-38.
[9]	张增猛;周华;高院安;杨华勇. 水辅助注射成型充模流动的仿真与分析[J]. , 2010, 46(8): 140-146.
[10]	朱昌盛;冯力;王智平;肖荣振. 二元合金三维枝晶生长的相场法数值模拟[J]. , 2009, 45(1): 88-93.
[11]	梁瑛娜;高殿荣. 双层直斜叶及其组合桨搅拌槽三维流场数值模拟[J]. , 2008, 44(11): 290-297.
[12]	陈辉;胡元中;王慧;王文中. 粗糙表面分形特征的模拟及其表征[J]. , 2006, 42(9): 219-223.
[13]	邓兆祥;胡玉梅;王攀;刘波;江万里;刘惊涛. 客车耐撞性结构优化设计[J]. , 2005, 41(11): 217-220.
[14]	周国发;孙懋. 聚合物全三维非稳态非等温多相分层流动成型过程的理论模型和数值模拟[J]. , 2004, 40(9): 16-22,2.
[15]	安刚;李俊明;王补宣. 微小矩形通道内气体层流换热的数值模拟[J]. , 2001, 37(7): 5-8.

基于Sola算法强迫层流纯物质枝晶生长相场法模拟

Phase-field Simulation of Pure Material Dendritic Growth Based on Sola Algorithm in Force Laminar Flow

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价