• CN：11-2187/TH
  • ISSN：0577-6686
机械工程学报

›› 1989, Vol. 25 ›› Issue (2): 16-21.

• 论文 • 上一篇    下一篇

TIPS-1几何造型系统用于锻模CAD/CAM的评价和进展

陈国学;Y.Van Hoenaker   

  1. 清华大学;加拿大舍布鲁克大学
  • 发布日期:1989-03-01

THE EVALUATION AND EVELOPMENT OF TIPS-1 GEOMETRIC MODELLING SYSTEM FOR CAD/CAM OF FORGING DIES

Chen Guoxue Y.Van Hoenaker   

  1. Qinghua University Universiy of Sherbrooke
  • Published:1989-03-01

摘要： 分析了TIPS-1几何造型系统用于三维模锻件及其模具设计制造的可能性和问题，针对其中一些问题，对该系统做了改造和发展，包括：发展了一个零件层次运算系统，用于产生模具型槽；加强了该系统剖取截面的能力；发挥了一个新处理器用来处理截面数据，从而获得单个锻件或一组锻件的等效毛坯图。

关键词: 锻造, 计算机辅助设计

Abstract: The potential of TIPS-1version 77 for the designing and manufacturing of 3-D forgings and their dies are evaluated. Some improvements of TIPS-1 are introduced to correct the deficiencies which are noted, including the development of a part level operation system to produce die cavities, the enhancement of the capability to obtain sections, and the development of a new Processor to process the section data so that the equivalent bar diagram for a single forging or a group of forgings can be drawn.

Key words: 锻造, 计算机辅助设计

版权所有 © 2019 《机械工程学报》编辑部 | 京icp备05055788号-40