流体介质中沉没辊模型附加质量和附加阻尼试验研究

doi:10.3901/JME.2020.10.235

机械工程学报 ›› 2020, Vol. 56 ›› Issue (10): 235-243.doi: 10.3901/JME.2020.10.235

扫码分享

流体介质中沉没辊模型附加质量和附加阻尼试验研究

王兴东¹, 胡安¹, 胡溧², 涂琪瑞¹, 李友荣¹, 吴宗武¹

1. 武汉科技大学冶金装备及其控制教育部重点实验室武汉 430081;
2. 武汉科技大学汽车 NVH 及声品质工程实验室武汉 430081

收稿日期:2019-06-09 修回日期:2020-03-10 出版日期:2020-05-20 发布日期:2020-06-11
通讯作者: 王兴东(通信作者),男,1970年出生,博士,教授。主要研究方向为机械设计和工业自动化检测技术、机械振动理论、振动分析与控制。E-mail:wangxingdong@wust.edu.cn
基金资助:
国家自然科学基金资助项目（51775391）。

Experimental Investigation of Added Mass and Damping on Model of Sink Roll in Fluid Media

WANG Xingdong¹, HU An¹, HU Li², TU Qirui¹, LI Yourong¹, WU Zongwu¹

1. Key Laboratory of Metallurgical Equipment and Control Technology, Wuhan University of Science and Technology, Wuhan 430081;
2. Automobile NVH and Sound Quality Laboratory, Wuhan University of Science and Technology, Wuhan 430081

Received:2019-06-09 Revised:2020-03-10 Online:2020-05-20 Published:2020-06-11

摘要/Abstract

摘要： 为准确分析不同流体介质中沉没辊模型附加质量和附加阻尼的变化规律，建立理论计算分析模型，对4种模型在4种流体中进行模态试验。利用锤击法，分别对加杆和不加杆的沉没辊模型进行空气中模态试验，两者结果一致性较高。加杆沉没辊模型的试验结果分析可知，水和液压油中前六阶的频响函数曲线峰值明显，甘油中仅前三阶明显；甘油的黏度变化对模型固有频率的影响较小，但随其黏度的增大其附加阻尼因数增加；随着液体密度增加，模型各阶振型对应的附加质量因数均呈线性增加，且当结构的质量和刚度增大时，其增加的斜率减小；随着结构密度增大，模型附加质量因数减小；所有模型（1，2）和（2，2）振型的附加质量因数大于弯曲振型。

关键词: 沉没辊模型, 模态试验, 附加阻尼, 附加质量, 流体密度

Abstract: In order to accurately analyze the change laws of added mass and damping of sink roll models in different fluid media, an analysis model of theoretical calculation is established, and four kinds of models are tested in four kinds of fluids. Using the hammer method, the modal tests in air are performed on the sink roll models with and without rods. Respectively, the result is highly consistent. The analysis of the test results of the tie-in model show that the first six orders of frequency response function curved in water and hydraulic oil are obvious, however only the first three orders are significant in glycerol; the viscosity change of glycerol has little effect on the natural frequency of the model, but the viscosity increases with the increase of the added damping coefficient. With the increase of the liquid density, the corresponding added mass coefficient of each mode of the model increases linearly. Otherwise, when the structure's mass and stiffness increases, the increasing slope decreases. With the increase of structural density, the added mass coefficient of the model decreases; the added mass coefficient of all models (1,2) and (2,2) are greater than the bending mode.

Key words: model of sink rolls, modal test, added damping, added mass, fluid density

中图分类号:

TH113

王兴东, 胡安, 胡溧, 涂琪瑞, 李友荣, 吴宗武. 流体介质中沉没辊模型附加质量和附加阻尼试验研究[J]. 机械工程学报, 2020, 56(10): 235-243.

WANG Xingdong, HU An, HU Li, TU Qirui, LI Yourong, WU Zongwu. Experimental Investigation of Added Mass and Damping on Model of Sink Roll in Fluid Media[J]. Journal of Mechanical Engineering, 2020, 56(10): 235-243.

参考文献

[1] 王兴东,黄毫军,李友荣,等. 沉没辊装置液固耦合数值模拟及振动实验[J]. 北京科技大学学报,2016,38(12):1778-1783. WANG Xingdong,HUANG Haojun,LI Yourong,et al. Liquid-solid coupling numerical simulation and vibration experiment of sunken roller device[J]. Journal of University of Science and Technology Beijing,2016,38(12):1778-1783.
[2] VALENTIN D,PRESEA A,EGUSQUIZA E,et al. Experimental study on the added mass and damping of a disk submerged in a partially fluid-filled tank with small radial confinement[J]. Journal of Fluids & Structures,2014,50:1-17.
[3] VALENTIN D,PRESEA A,EGUSQUIZA E,et al. Experimental study of a vibrating disk submerged in a fluid-filled tank and confined with a nonrigid cover[J]. Journal of Vibration & Acoustics,2017,139(2):021005.
[4] 王兴东,刘灿灿,李友荣,等. 热镀锌线沉没辊装置振动分析与结构优化[J]. 华中科技大学学报,2017,45(12):118-122. WANG Xingdong,LIU Cancan,LI Yourong,et al. Research on vibration analysis and structure optimization of sink roll in hot-dip galvanizing line[J]. Journal of Huazhong University of Science and Technology,2017,45(12):118-122.
[5] 黄毫军,王兴东,李友荣,等. 热镀锌沉没辊装置振动固有特性影响因素研究[J]. 机械科学与技术,2016,35(2):187-191. HUANG Haojun,WANG Xingdong,LI Yourong,et al. A study of influential factors on vibration inherent characteristics of sink roll device of hot dip galvanized[J]. Mechanical Science and Technology for Aerospace Engineering,2016,35(2):187-191.
[6] RODRIGUE C G,EGUSQUIZA E,ESCALER X,et al. Experimental investigation of added mass effects on a Francis turbine runner in still water[J]. Journal of Fluids & Structures,2006,22(5):699-712.
[7] 赵信智. 核主泵叶轮湿模态特性分析与实验研究[D]. 大连:大连理工大学,2016. ZHAO Xinzhi. Analysis and experimental research on wet modal characteristics of nuclear main pump impeller[D]. Dalian:Dalian University of Technology,2016.
[8] NAIK T,LONGMIRE E K,MANTELL S C. Dynamic response of a cantilever in liquid near a solid wall[J]. Sensors & Actuators A Physical,2003,102(3):240-254.
[9] BERGAUD C,NICU L. Viscosity measurements based on experimental investigations of composite cantilever beam eigenfrequencies in viscous media[J]. Review of Scientific Instruments,2000,71(6):2487-2491.
[10] 刘瑞骏,郝志勇,郑旭,等. 流固耦合对油底壳振-声特性的影响研究[J]. 北京理工大学学报,2017,37(1):37-41. LIU Ruijun,HAO Zhiyong,ZHENG Xu,et al. Effect of fluid-solid coupling on the vibration acoustic characteristics of oil pan[J]. Journal of Beijing Institute of Technology,2017,37(1):37-41.
[11] RODRIGUEZ C G,EGUSQUIZA E,ESCALER X,et al. Experimental investigation of added mass effects on a Francis turbine runner in still water[J]. Journal of Fluids & Structures,2006,22(5):699-712.
[12] KWAK M K,AMABILI M. Hydroelastic vibration of free-edge annular plates[J]. Journal of Vibration & Acoustics,1999,121(1):26-32.
[13] LIANG C C,LIAO C C,TAI Y S,et al. The free vibration analysis of submerged cantilever plates[J]. Ocean Engineering,2001,28(9):1225-1245.
[14] 夏金凤. 制动盘模态特性及其影响因素分析[D]. 重庆:重庆大学,2015. XIA Jinfeng. Analysis of modal characteristics and influence factors of brake discs[D]. Chongqing:Chongqing University,2015.
[15] MAHERI M R,SEVERN R T. Experimental added-mass in modal vibration of cylindrical structures[J]. Engineering Structures,1992,14(3):163-175.
[16] 顾培英,邓昌,吴福生. 结构模态分析及其损伤诊断[M]. 南京:东南大学出版社,2008. GU Peiying,DENG Chang,WU Fusheng. Structural modal analysis and damage diagnosis[M]. Nanjing:Southeast University Press,2008.
[17] 全国图算学培训中心. 化学化工物性数据手册[M]. 北京:化学工业出版社,2013. National Tutoring Training Center. Chemical properties data book[M]. Beijing:Chemical Industry Press,2013.

流体介质中沉没辊模型附加质量和附加阻尼试验研究

Experimental Investigation of Added Mass and Damping on Model of Sink Roll in Fluid Media

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 7

编辑推荐

Metrics

本文评价

[1]	曹雪梅, 何宏图, 魏冰阳, 许浩. 螺旋锥齿轮数字孪生体模态参数的提取与分析[J]. 机械工程学报, 2023, 59(13): 260-267.
[2]	袁晓明, 王储, 赵士宜, 张立杰. 消防炮自适应炮头射流系统自由振动分析[J]. 机械工程学报, 2020, 56(22): 256-262.
[3]	宫岛, 周劲松, 杜帅妹, 孙文静, 孙煜. 高速动车组车下设备对车体振动传递与模态频率的影响机理研究^*[J]. 机械工程学报, 2016, 52(18): 126-133.
[4]	郭垒;张辉;汪劲松;叶佩青. 元结构方法的理论建模和验证[J]. , 2011, 47(23): 135-143.
[5]	纪跃波;赵淳生. 超声波电动机面内振动模态试验测试系统[J]. , 2006, 42(2): 110-114.
[6]	蔡国平;洪嘉振. 考虑附加质量的中心刚体—柔性悬臂梁系统的动力特性研究[J]. , 2005, 41(2): 33-40.
[7]	苏玉鑫;段宝岩;魏强;南仁东;彭勃. 基于电流变液的大射电望远镜馈源支撑系统风振阻尼控制[J]. , 2001, 37(3): 46-50，5.