陀螺框架轴承摩擦力矩分析

doi:10.3901/JME.2016.07.060

摘要/Abstract

摘要： 针对陀螺框架轴承要求启动摩擦力矩小而稳定的苛刻要求,建立轴承摩擦力矩分析模型,在已有的球与内外圈弹性滞后、差动、自旋、润滑影响因素引起的摩擦力矩分析基础上,重点考虑浪形及冠型保持架引起的摩擦力矩。求得的轴承启动、动态摩擦力矩与YZC-II测试仪测试结果吻合较好。分析表明,浪形保持架整体优于冠型保持架,保持架与球作用引起的摩擦力矩比例随轴向载荷减小而增大,该比重在启动过程中较大,在动态过程明显降低;通过对4种型号框架轴承不同转速的摩擦力矩分析,当转速低于2 r/min时,轴承摩擦力矩受转速影响不大,随着速度增大,启动速度对轴承启动摩擦力矩值、动态摩擦力矩波动范围影响突显出来。

关键词: 动态摩擦力矩, 冠型保持架, 浪形保持架, 启动摩擦力矩, 陀螺框架轴承

Abstract: For the applications of demanding small and stable friction moment of gyroscope frame bearings, the model of bearing’s friction moment is built. Based on the existing analyses that include the friction moments caused by elastic hysteresis, sliding due to the contact race curvature, pivoting between the ball and the inner/outer race and lubrication, the friction moment caused by ribbon or crown cage are mainly introduced. Through comparing the calculated bearing’s starting and kinematic friction moment to the experimental results measured by YZC-II tester, an acceptable consistent is achieved. The analyses show that the proportion of friction moment caused by cage increases with the decreasing loads. This proportion is larger in the bearing’s starting friction moment and smaller in the kinematic friction moment. According to the calculated results of 4 kinds of frame bearings at different speeds, the speed has little influence on the friction moment when the bearings work at lower 2 r/min, but when the speed increases, it will have a big influence on the value of starting friction moment and the fluctuation range of kinematic friction moment.

Key words: crown cage, gyroscope frame bearing, kinematic friction moment, ribbon cage, starting friction moment

中图分类号:

TH133

姜绍娜, 陈晓阳, 顾家铭, 张涛. 陀螺框架轴承摩擦力矩分析[J]. 机械工程学报, 2016, 52(7): 60-68.

JIANG Shaona, CHEN Xiaoyang, GU Jiaming, ZHANG Tao. Analysis of Friction Moment of Gyroscope Frame Bearing[J]. Journal of Mechanical Engineering, 2016, 52(7): 60-68.

参考文献

[1] 刘春浩,顾家铭,周赤忠,等．陀螺仪电动机转子轴承研究现状与展望[J]．机械工程学报,2006,42(11)：17-25．
LIU Chunhao,GU Jiaming,ZHOU Chizhong,et al．Research of present state and prospective on gyro-spin bearings[J]．Chinese Journal of Mechanical Engineering,2006,42(11)：17-25．
[2] 朱江红．低速球轴承摩擦力矩的分析研究[J]．导弹与航天运载技术,2000(6)：20-25．
ZHU Jianghong．The research of the friction moment of low speed ball bearing [J]．Missiles and Space Vehicles,2000(6)：20-25．
[3] 李建华,张葵,卢振伟．表面特性对灵敏轴承摩擦力矩的影响分析[J]．轴承,1999(9)：17-19．
LI Jianhua,ZHANG Kui,LU Zhenwei．Analysis of the influence of surface characteristics on sensitive bearing friction torque [J]．Bearing,1999(9)：17-19．
[4] 李建华,邓四二,马纯民．陀螺仪框架灵敏轴承摩擦力矩影响因素分析[J]．轴承,2006(7)：4-7．
LI Jianhua, DENG Sier,MA Chunmin．Analysis of friction moment factors of gyroscope frame sensitive bearings[J]．Bearing,2006(7)：4-7．
[5] 马小梅,邓四二,梁波,等．航天轴承摩擦力矩的试验分析[J]．轴承,2005(10)：22-24．
MA Xiaomei,DENG Sier,LIANG Bo,et al．Test analysis of friction moment of space bearings[J]．Bearing,2005(10)：22-24．
[6] HARRIS T A．Rolling bearing analysis[M]．Boca Raton：CRC Press Inc.,1991．
[7] JONES A B. Ball motion and sliding friction in ball bearings[J]. Journal of Basic Engineering,Transactions of the ASME,1959,81：1-12．
[8] 叶军,杨立芳,吉智军,等．框架轴承摩擦力矩的测量与分析计算[J]．轴承,2001(4)：7-9．
YE Jun,YANG Lifang,JI Zhijun,et al．Measurement and analysis of friction moment of frame bearing[J]．Bearing,2001(4)：7-9．
[9] 徐荣瑜．角接触球轴承摩擦力矩的计算[J]．轴承,1994(6)：2-5．
XU Rongyu．Calculation of friction moment of angular contact ball bearing [J]．Bearing,1994(6)：2-5．
[10] TODD M J．Selected ESTL papers on ball bearings for satellites[R]. ESA Trib/1,1980.
[11] HOUPERT L．Numerical and analytical calculations in ball bearing[C]// Proceedings of the 8th European Space Mechanisms and Tribology Symposium,Toulouse,France,1999：283-290．
[12] 姜绍娜,陈晓阳,顾家铭,等．低速灵敏球轴承摩擦力矩分析[J]. 中国机械工程,2010(5)：510-514.
JIANG Shaona,CHEN Xiaoyang,GU Jiaming,et al．Analysis of friction torque of sensitive ball bearing under low speed[J]．China Mechanical Engineering,2010(5)：510-514．
[13] 席颖佳,阮伟芳,李红,等．低摩擦力矩轴承的研制[J]轴承,2002(10)：13,27．
XI Yingjia,RUAN Weifang, LI Hong,et al． Development of low friction torque of bearings [J]．Bearing,2002(10)：13,27．
[14] 查全. 微型轴承技术精编[M]. 上海：上海交通大学出版社,1992．
CHA Quan. Technology of miniature bearing[M]. Shanghai：Shanghai Jiao Tong University Press,1992．
[15] 姜绍娜,陈晓阳,顾家铭,等．航天仪表轴承极低速下保持架摩擦力矩分析[J]. 宇航学报,2014,35(1)： 47-53．
JIANG Shaona,CHEN Xiaoyang,GU Jiaming,et al．The analysis of friction moment caused by cage of aerospace instrument bearing at the ultra-low speed[J]．Journal of Astronautics,2014,35(1)：47-53．