两级单螺杆膨胀机空气动力系统性能研究

›› 2010, Vol. 46 ›› Issue (10): 139-143.

两级单螺杆膨胀机空气动力系统性能研究

何为;吴玉庭;马重芳;马国远

北京工业大学传热强化与过程节能教育部重点实验室;北京工业大学传热与能源利用北京市重点实验室

发布日期:2010-05-20

Research of Air Powered Engine System Using Two-stage Single Screw Expander

HE Wei;WU Yuting;MA Chongfang;MA Guoyuan

The Key Laboratory of Enhanced Heat Transfer and Energy Conservation, Ministry of Education, Beijing University of Technology The Key Laboratory of Heat Transfer and Energy Conversion, Beijing Municipality,Beijing University of Technology

Published:2010-05-20

摘要/Abstract

摘要： 为了克服单螺杆气动汽车发动机单级动力系统能量利用率低的缺陷，应用热力学理论对压缩空气两级动力系统性能进行研究，采用变尺度数学优化算法建立数学模型，对两级系统的级间分配进行优化，并通过编程计算，对其获得的级间膨胀比优化结果进行验证，分析系统总效率和加热温度等因素对系统动力性能参数——总输出功和气耗率的影响。理论研究结果表明，储气压力30 MPa，储气容积300 L的两级系统，当各级入口温度相同时，其最优膨胀比组合为10∶7，此外，9∶7和9∶8也可作为优化膨胀比；系统效率和加热温度越高，系统的总输出功也越大，气耗率与之相反。证明采用两级系统并结合级间加热方式时可以大大改善系统的性能。

关键词: 单螺杆, 气动汽车发动机, 压缩空气

Abstract: A new compressed air engine system based on two-stage single screw expander is proposed to increase the energy utilization rate of compressed air. The distribution of expansion ratios between stages is optimized by building mathematical optimal arithmetic model with variable metric method and is checked by programming calculation. The influence of total efficiency and heating temperature on the power performance parameters including total output work and air consumption rate is analyzed. Research results indicate the best match of expansion ratio is ten to seven (nine to seven and nine to eight are also good) for the same inlet temperature system with air tank of 30 MPa pressure and 300 L volume. Results also show that heating up inlet air or increasing the system efficiency can improve the total output work and reduce the air consumption rate. It is concluded that the compressed air engine system combined two-stage single screw expander with heating is better than single-stage system.

Key words: Air powered engine, Compressed air, Single screw

中图分类号:

U469.76 TK05 U461.1

何为;吴玉庭;马重芳;马国远. 两级单螺杆膨胀机空气动力系统性能研究[J]. , 2010, 46(10): 139-143.

HE Wei;WU Yuting;MA Chongfang;MA Guoyuan. Research of Air Powered Engine System Using Two-stage Single Screw Expander[J]. , 2010, 46(10): 139-143.

[1]	沈丽丽, 王伟, 吴玉庭. 单螺杆膨胀机泄漏通道长度变化规律的理论分析[J]. 机械工程学报, 2015, 51(24): 126-131.
[2]	张业强, 吴玉庭, 夏国栋, 马重芳, 吉威宁, 刘闪威, 王景甫, 郭, 航. 单螺杆膨胀机在有机朗肯循环系统中的性能研究[J]. 机械工程学报, 2015, 51(16): 156-163.
[3]	董添文;江顺亮;黄兴元;柳和生. 基于不可压缩光滑粒子流体动力学的单螺杆挤出三维流动数值模拟[J]. , 2012, 48(22): 80-86.
[4]	徐百平;喻慧文;何亮;陈金伟;王玫瑰;刘跃军. 带有扰动副螺棱的单螺杆挤出机内混沌混合[J]. , 2012, 48(14): 70-77.
[5]	何为;吴玉庭;马重芳;庄荟燕. 单螺杆发动机空气动力系统能效分析[J]. , 2011, 47(6): 150-155.
[6]	李锦上. 空间共轭啮合副二次包络面三面共点构造法[J]. , 2011, 47(21): 43-48.
[7]	任彬;张树有. 双头单螺杆泵短幅内摆线线型仿真优化技术[J]. , 2009, 45(9): 144-151.
[8]	左承基;王斌;傅秋阳;欧阳明高;杨福源. 配气系统参数对压缩空气发动机性能的影响[J]. , 2008, 44(4): 211-216.
[9]	蔡茂林;香川利春. 气动系统的能量消耗评价体系及能量损失分析[J]. , 2007, 43(9): 69-74.
[10]	俞小莉;元广杰;沈瑜铭;刘震涛;苏石川. 气动汽车发动机工作循环的理论分析[J]. , 2002, 38(9): 118-122.