• CN：11-2187/TH
  • ISSN：0577-6686
机械工程学报

›› 2004, Vol. 40 ›› Issue (8): 106-109.

• 论文 • 上一篇    下一篇

扫码分享

采用可移动凹模的板材液压成形技术

许沂;周丽新;张士宏;王忠堂   

  1. 中国科学院金属研究所;沈阳工业学院材料科学与工程系
  • 发布日期:2004-08-15

HYDROFORMING OF SHEET METAL WITH A MOVABLE DIE COMPONENT

Xu Yi;Zhou Lixin;Zhang Shihong;Wang Zhongtang   

  1. Institute of Metal Research,Chinese Academy of Sciences Department of Material Science and Engineering, Shenyang Institute of Technology
  • Published:2004-08-15

PDF

157

摘要： 提出一种改进的板材液压成形新工艺，即采用可移动凹模，实现拉深与胀形的复合液压成形。在整个变形过程中，板材初始变形部分始终与可移动凹模接触，从而抑制已变形区进一步变形，使变形更加均匀，实现变形的顺序控制，板材成形极限得到提高。从试验和数值模拟两方面对可移动凹模板材液压成形技术进行了研究，分析各种工艺参数，如摩擦因数等对板材成形性的影响，并且分析了可移动凹模对板材成形极限的影响。

关键词: 板材成形, 可移动凹模, 液压成形

Abstract: A modified sheet hydroforming process is investigated experimentally and numerically, the female die is movable and can keep in contact with the deformed area of the sheet blank so that further deformation on the deformed area is decreased. The flange of the sheet blank can be drawn in with a suitable sealing method, therefore the hydroformed part has less thinning than hydrobulge formed only part, the limit drawing ratio of the sheet can be remarkably increased. The explicit finite element method is used to analyze the hydroforming process of the sheet parts. Various process parameters are tried to investigate their effects on the deformation of the sheet blanks. The effects of contacting force act on the experimental results.

Key words: Hydroforming, Movable die, Sheet metal forming

中图分类号: 

版权所有 © 2019 《机械工程学报》编辑部 | 京ICP备05055788号-30