• CN:11-2187/TH
  • ISSN:0577-6686

›› 1999, Vol. 35 ›› Issue (2): 23-27,4.

• 论文 • 上一篇    下一篇

相伴曲面方法及其在机构运动几何学研究中的应用

王德伦;刘健;肖大准   

  1. 大连理工大学机械工程系
  • 发布日期:1999-03-01

NEW ADJOINT APPROACH AND ITS APPLICATION IN THE KINEMATIC GEOMETRY RESEARCH OF MECHANISMS

Wang Delun;Liu Jian;Xiao Dazhun   

  1. Dalian University of Technology
  • Published:1999-03-01

摘要: 将微分几何学中的曲线与曲线相伴方法发展到曲线与直纹面、直纹面与直纹面相伴方法,应用于机构运动几何学研究。分别以约束曲线和约束曲面为原曲线和原曲面,导出了连杆运动的瞬心线或瞬轴面及其不变量的表达式,提示了其运动学意义,加之引入不动点、不动性和准不动线条件,完整地描述了连杆点和直线的轨迹与瞬轴面的内在联系。为机构运动几何学研究提供了新的有力工具。

关键词: 机构, 相伴曲面方法, 运动几何学, 非接触测量, 激光测距, 平面度, 误差评定

Abstract: A new adjoint approach is developed from differential geometry and is applied to research the kinematic geometry of planar and spatial mechanisms. The constraint curves and the constraint ruled surface of mechanisms are taken as the origin curves and the origin ruled surfaces respetively. A point trajectory and a line trajectory are visualized as an adjoint curve and an adjoint ruled surface, whose invariants are represented by that of the origin curve and surface. The centrodes or axodes are examined as a special case of the adjoint curve or the adjoint surface, whose invariants are exposed in terms of the origin curves and origin surfaces. By taking the centrodes of the axodes and the parameters of the mechanism. The kinematic geometric proparties of a mechanism are revealed in terms of their invariants.

Key words: Adjoint approach, geometry, Kinematic, Mechanisms, Error evaluation, Flatness, Laser ranging, Non-contact measurement

中图分类号: