• CN:11-2187/TH
  • ISSN:0577-6686

›› 1956, Vol. 4 ›› Issue (2): 239-262.

• 论文 • 上一篇    下一篇

扫码分享

用逐波叠加法分析水锤现象的研究

潘家铮   

  1. 上海水力发电设计院
  • 发布日期:1956-06-01

WATER HAMMER PRESSURES ANALYZED BY METHOD OF SUPERPOSITION

Pan Chiacheng   

  1. Shanghai Design Institute of Hydroelectrical Engineering
  • Published:1956-06-01

摘要: 本文详尽的研究了水锤现象的基本分析法——逐波叠加法——的理论和应用。首先我们从儒可夫斯基的水锤波基本公式出发,论述了弹性波的生成、传播、反射、分射和部份反射的规律并导演了公式。特别是弹性波在阀门处的生成和部份反射公式(文中公式9),及在结点处的分射公式(文中公式14)为两个最基本的一般性公式。在理论上言,应用这两个公式已能解算任何复杂的管道系统中的水锤问题。文中后半部叙述了该法在实用中的步骤及需要表格,并举了简单管路,分段管路及分义管路等情况各设简单实例计算以供参考。例题的排列,是由简单到复杂。应用本文公式进行计算,对简单管路而言,可以避免试算之麻烦,且可获得任意所需之精度,此为一般数值积分法及图解法所不能及者。对复杂管路而言,亦可求得精确之答案,唯所需计算工作量较大,尚有待继续研究改进。本文为作者对水锤分析所作研究成果之一,另一部份关于用链方程式分析水锤现象的研究当另文论述。

Abstract: This paper investigates the principles and practices of the foundamental analytical method. for computing water hammer pressures, namely, method by superposition of elastic waves. This method is lisle known or adopted in practical work due to the fact that though its principles are simple and direct, the required computing work is tedious and difficult, because the number of waves generated at the operating gate and propagated 11I the pipe line system increases indefinitely as they reflect and divide at each joints, except for the most simple case. The purposes of this paper are: (1) Describe the foundamental principles of this method and derive useful formulas in more complete form; (2) Present general working procedure. and convenient computing tables to simplify the numerical work and bring the method more adoptable for practical use. Typical numerical examples are given to show the procedure of computation in detail and finally some conclusions about this method are discussed. Analysis of water hammer pressures by using another important method "the conjugate-equation method" either graphycally or arithmetically has also been studied by the writer and the results will be discussed in an another paper.