• CN:11-2187/TH
  • ISSN:0577-6686

机械工程学报 ›› 2026, Vol. 62 ›› Issue (18): 445-453.doi: 10.3901/JME.260661

• 交叉与前沿 • 上一篇    

扫码分享

寻址超声传感器阵列波阵面自适应补偿方法研究

宋寿鹏, 王心悦, 向运杰, 沈奇超   

  1. 江苏大学仪器科学与工程系 镇江 212013
  • 收稿日期:2025-10-10 修回日期:2026-05-06 发布日期:2026-11-20
  • 作者简介:宋寿鹏,男,1967年出生,教授,博士研究生导师。主要研究方向为超声无损检测。E-mail:songshoupeng@126.com
  • 基金资助:
    国家自然科学基金资助项目(52175511)。

Research on Adaptive Wavefront Compensation Method for Addressed Ultrasonic Sensor Array

SONG Shoupeng, WANG Xinyue, XIANG Yunjie, SHEN Qichao   

  1. Department of Instrument Science and Engineering, Jiangsu University, Zhenjiang 212013
  • Received:2025-10-10 Revised:2026-05-06 Published:2026-11-20

摘要: 超声传感器阵列波阵面精确控制是实现阵列波束电子扫描的关键技术,与传统的超声相控阵波阵面精确控制方法相比,寻址超声传感器阵列在传感器阵列结构、控制时序产生以及控制信号传输路径上均存在差异。为此,研究了寻址超声传感器阵列检测系统平面波阵面形成机理,并分析了波阵面性能的影响因素,利用时间数字转换器(Time-to-digital converter, TDC)原理设计了实时相位测量电路,并通过FPGA修正控制时序,以实现波阵面相位自适应补偿。对比分析了相位补偿前后的阵列波束指向性与波阵面质量,补偿后波束旁瓣级降低了8.57~9.3 dB,波阵面平面度衡量指标RMSE最低达到了0.010 4。在铝试块 4 mm通孔缺陷上分别进行了0°、15°、30°和45°四种角度平面波检测,结果表明,补偿后的检测回波信噪比提升了1.36~2.72 dB。

关键词: 超声检测, 寻址传感器阵列, 波阵面, 精确控制, 自适应

Abstract: Precise control of the wavefront in ultrasonic transducer arrays constitutes a key technology for achieving electronic beam steering. Compared with traditional ultrasonic phased array wavefront control methods, addressing ultrasonic transducer arrays exhibit differences in array structure, control timing generation, and signal transmission pathways. The formation mechanism of plane wavefronts in addressing ultrasonic transducer array inspection systems is investigated, and influencing factors on wavefront performance are analyzed. A real-time phase measurement circuit was designed based on the time-to-digital converter (TDC) principle, while FPGA-based timing correction was implemented to achieve adaptive phase compensation for wavefront control. Comparative analysis of array beam directivity and wavefront quality before and after phase compensation demonstrated that the sidelobe level was reduced by 8.57-9.3 dB, and the root mean square error (RMSE), the quantitative metric for wavefront flatness, reached a minimum of 0.0104. Plane wave inspections at 0°, 15°, 30°, and 45° were conducted on an aluminum test block containing through-hole defect with a diameter of 4 mm (F 4 mm). Results showed that the signal-to-noise ratio of detection echoes improved by 1.36-2.72 dB after compensation.

Key words: ultrasonic inspection, addressing transducer array, wavefront, precise control, adaptive

中图分类号: