Design, Characterization and Testing of Magnetically Coupled Piezoelectric Vibration Energy Harvester Using Double Magnets

doi:10.3901/JME.2022.20.150

Abstract

Abstract: In view of some drawbacks of many existing piezoelectric vibrator energy harvesters, a magnetically coupled piezoelectric vibration energy harvester using double magnets is proposed to meet the demands of self-powered remote monitoring systems in this paper. This harvester was characterized by the combined transducer, where two piezoelectric vibrators were symmetrically fixed on each side of the additional elastic beam and thus the vibrators were mainly subjected to the unidirectional compressive stress. To figure out the effect of the involved structural parameters on the harvester’s performance, the simulation was firstly conducted based on the theoretical modelling. The results indicated that the vertical distance between two fixed magnets as well as the horizontal distance between the fixed magnet and movable magnet brought a significant impact on the potential energy of the system. Also, the dynamic response characteristics of the harvester under different excitation situations were obtained. Then, a harvester prototype was fabricated and its output characteristics was tested to verify the feasibility of the energy harvester and the correctness of the simulation results. The experimental results showed that the excitation frequency had a great influence on the output voltage waveform of the energy harvester. Meanwhile, with an appropriate vertical and horizontal distance (11≤d≤12 mm, 10≤l≤16 mm), not only the natural frequency of the energy harvester could be significantly reduced and the working bandwidth could be broadened, but also a relatively flat voltage-frequency curve could be obtained in a quite wide frequency range. Thus, the environmental adaptability and reliability of the energy harvester was further improved. Besides, the maximum output powers of 1.27 mW, 2.88 mW and 5.31 mW were achieved with an optimal load resistance of 70 kΩ at the excitation frequency of 12 Hz, 16 Hz and 20 Hz, respectively.

Key words: piezoelectric, vibration energy harvester, magnetic coupling, combined transducer, broadband

CLC Number:

TN384
TM619

WANG Shuyun, REN Zefeng, KAN Junwu, YANG Zemeng, ZHANG Zhonghua, HUANG Leshuai, MENG Fanxu. Design, Characterization and Testing of Magnetically Coupled Piezoelectric Vibration Energy Harvester Using Double Magnets[J]. Journal of Mechanical Engineering, 2022, 58(20): 150-157.

Add to citation manager EndNote|Reference Manager|ProCite|BibTeX|RefWorks

URL: http://www.cjmenet.com.cn/EN/10.3901/JME.2022.20.150

http://www.cjmenet.com.cn/EN/Y2022/V58/I20/150

References

[1] 阚君武，张肖逸，王淑云，等. 一种错位旋磁激励压电俘能器[J]. 中国机械工程，2016，27(16):2207-2210. KAN Junwu，ZHANG Xiaoyi，WANG Shuyun，et al. A piezoelectric harvester excited by malposed rotary magnets[J]. China Mechanical Engineering，2016，27(16): 2207-2210.
[2] ZHANG Z，WANG S，KAN J，et al. A pneumatic piezoelectric vibration energy harvester based on the compressed air-transducer-structure interaction[J]. Energy Conversion and Management，2010，213:112861.
[3] FAN K，LIU J，CAI M，et al. Exploiting ultralow-frequency energy via vibration-to-rotation conversion of a rope-spun rotor[J]. Energy Conversion and Management，2020，225:113433.
[4] WANG J，GENG L，DING L，et al. The state-of-the-art review on energy harvesting from flow-induced vibrations[J]. Applied Energy，2020，267:114902.
[5] TRAN N，GHAYESH M H，ARJOMANDI M. Ambient vibration energy harvesters:A review on nonlinear techniques for performance enhancement[J]. International Journal of Engineering Science，2018，127:162-185.
[6] 樊康旗，刘朝辉，王连松，等. 从人体行走中收集能量的鞋上压电俘能器[J]. 光学精密工程，2017，25(5):1272-1280. FAN Kangqi，LIU Zhaohui，WANG Liansong，et al. Shoe-mounted piezoelectric energy harvester for collecting energy from human walking[J]. Optics and Precision Engineering，2017，25(5):1272-1280.
[7] KAN J，FU J，WANG S，et al. Study on a piezo-disk energy harvester excited by rotary magnets [J]. Energy，2017，122:62-69.
[8] ZHANG Z，KAN J，WANG S，et al. Performance dependence on initial free-end levitation of a magnetically levitated piezoelectric vibration energy harvester with a composite cantilever beam[J]. IEEE Access，2017，5:27563-27572.
[9] SIDDIQUE A R，MAHMUD S，van HEYST B，et al. A comprehensive review on vibration based micro power generators using electromagnetic and piezoelectric transducer mechanisms[J]. Energy Conversion and Management，2015，106:728-747.
[10] 王淑云，余杰，阚君武，等. 腔式压电气流发电机结构与性能研究 [J]. 农业机械学报，2018，49(1):421-425. WANG Shuyun，YU Jie，KAN Junwu，et al. Structure and performance of piezoelectric airflow energy harvester [J]. Transactions of the Chinses Society for Agricultural Machinery，2018，49(1):421-425.
[11] JI H，QIU J，ZHU K. Vibration control of a composite beam using self-sensing semi-active approach[J]. Chinese Journal of Mechanical Engineering，2010，23(5):663-670.
[12] 耿彦超，胡嘉骏，汪雪良，等. 基于模型试验的江海直达船波激振动与砰击载荷研究[J]. 中国造船，2014，55(3):43-52. GENG Yanchao，HU Jiajun，WANG Xueliang，et al. Investigation of spring and slamming loads on river-to-sea ships by model test[J]. Shipbuilding of China，2014，55(3):43-52.
[13] 武俊达，董大伟，闫兵，等. 液压模块挂车刚柔耦合动态响应特性及摆臂疲劳分析[J]. 振动与冲击，2014，33(7):37-44. WU Junda，DONG Dawei，YAN Bing，et al. Dynamic response characteristics and swing-arm fatigue analysis for a hydraulic modular trailer based on rigid-flexible coupling simulation[J]. Journal of Vibration and Shock，2014，33(7):37-44.
[14] 姚丙盟，刘志平，李文锋. 基于双稳态的振动能量收集系统的设计[J]. 中国机械工程，2015，26(13):1736-1741. YAO Bingmeng，LIU Zhiping，LI Wenfeng. Design of vibration energy harvester based on bistability[J]. China Mechanical Engineering，2015，26(13):1736-1741.
[15] YANG Z，YANG J. Connected vibrating piezoelectric bimorph beams as a wide-band piezoelectric power harvester[J]. Journal of Intelligent Material Systems and Structures，2009，20(5):569-574.
[16] MASANA R，DAQAQ M F. Relative performance of a vibratory energy harvester in mono-and bi-stable potentials[J]. Journal of Sound and Vibration，2011，330(24):6036-6052.
[17] LIU H，LEE C，KOBAYASHI T，et al. Investigation of piezoelectric mems-based wideband energy harvesting system with assembled frequency-up-conversion mechanism[J]. Procedia Engineering，2011，25:725-728.
[18] HE X Q，RAFIEE M，MAREISHI S. Nonlinear dynamics of piezoelectric nanocomposite energy harvesters under parametric resonance[J]. Nonlinear Dynamics，2015，79(3):1863-1880.
[19] ANDÒ B，BAGLIO S，TRIGONA C，et al. Nonlinear mechanism in MEMS devices for energy harvesting applications[J]. Journal of Micromechanics and Microengineering，2010，20(12):125020.
[20] 王淑云，富佳伟，阚君武，等. 一种脱涡纵振式压电管道气流俘能器[J]. 机械工程学报，2019，55(8):24-29. WANG Shuyun，FU Jiawei，KAN Junwu，et al. A pipe airflows piezoelectric energy harvester with longitudinal vibration excited by vortex shedding [J]. Journal of Mechanical Engineering，2019，55(8):24-29.