• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (18): 311-320.doi: 10.3901/JME.260222

Previous Articles    

Study on Microstructure and Wear Resistance of Inconel 718 Alloy Coating Remanufactured by Microwave Heating

QIAN Zhengchun1,2, ZHANG Hengwei1, XU Hongmeng1, CHENG Huanbo1, DING Wenzheng1   

  1. 1. Nanjing Institute of Technology, School of Mechanical Engineering, Nanjing 211167;
    2. Anhui Key Laboratory of Low Carbon Recycling Technology and Equipment for Mechanical and Electrical Products, Hefei University of Technology, Hefei 230009
  • Received:2025-10-30 Revised:2026-05-12 Published:2026-11-20

Abstract: At present, the traditional remanufacturing technologies for nickel-based superalloy coatings mainly include laser cladding, plasma surfacing, and thermal spraying. However, they have limitations such as complex repair processes, high equipment costs, and the tendency to cause thermal damage. Therefore, a microwave heating remanufacturing (MHR) technology is innovatively proposed, and the Inconel 718 nickel-based superalloy coating is successfully prepared at the groove of remanufacturing core. The MHR coating shows a gradient distribution, in which the upper layer is dominated by dendrites, and a large number of chromium carbide hard phases appear in this zone. The middle layer of the powders undergoes four microwave heating stages of “micromelting-necking -liquefaction-filling” to form cellular crystals, accompanied by a large number of quasi-continuous network-like Laves phase precipitation as the enhanced skeleton. The lower matrix produces the chain-like Laves phase under the effect of heating. In addition, the microhardness of the MHR coating also shows a gradient distribution. The microhardness at the top of coating is the highest, and near the groove interface is the lowest. The friction and wear experiments show that the friction coefficient and wear weight of MHR coating are small, and the wear resistance is improved by more than 30%. The wear scar morphology shows that the dendrites on the top of MHR coating can withstand large normal load and transverse shear force. Besides, the fish-scale layered structure formed after dendrites bending can play a role of entrapping wear debris, which greatly improves the wear resistance of coating. The research results verify the great potential of MHR technology in repairing Inconel 718 nickel-based superalloy.

Key words: nickel-based superalloy, remanufacturing, microwave heating, repair, wear resistance

CLC Number: