• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (18): 299-310.doi: 10.3901/JME.260738

Previous Articles    

Mechanism of Biaxial Spinning-Extrusion Forming Thin-Walled Cylinders with Aluminum Alloy T-Ribs

XIONG Lingfeng1,2, FAN Xiaoguang1,2, ZHAN Mei1,2, ZHOU Dake3, BAI Danni1,2, MAN Qian4   

  1. 1. School of Material Science and Engineering, Northwestern Polytechnical University, Xi'an 710072;
    2. Shaanxi Key Laboratory of High-Performance Precision Forming Technology and Equipment, School of Materials Science and Engineering, Xi'an 710072;
    3. Beijing Satellite Manufacturing Co., Ltd., Beijing 100190;
    4. The Second Military Representative Office of Chengdu Bureau of Rocket Force in Xi'an Area, Xi'an 710199
  • Received:2025-10-29 Revised:2026-05-15 Published:2026-11-20

Abstract: The overall plastic forming of thin-walled cylinder with transverse T-shaped ribs is an urgent need for lightweight and low-cost manufacturing of advanced aerospace equipment. To address the difficulty in forming T-ribbed cylinders, this paper proposes a new biaxial spinning extrusion forming principle: based on the spinning platform, the T-shaped rib structure is formed by axial loading of the main spinning roller and radial loading of the auxiliary spinning roller. Using finite element simulation and experiments, the material deformation characteristics and flow behavior during spinning extrusion are analyzed, and the forming mechanism is revealed. The results show that the extrusion action of the main roller causes the rib material to elongate and flow outward in both the radial and circumferential directions, while the radial constraint of the auxiliary roller induces shear diversion at the rib top, making it easier to form the rib flange, but it tends to cause radial and axial transfer of the cylinder wall material, resulting in diameter expansion defects. Investigation of the expansion formation mechanism reveals that the circumferential deformation of the rib material is the key factor causing expansion. By changing the roller arrangement, increasing the friction factor and the cylinder wall thickness, the deformation constraint and the material flow resistance of the rib can be enhanced, thereby effectively suppressing expansion. A biaxial spinning extrusion forming experimental platform was built, and a qualified T-shaped rib tube sample with a high thickness ratio of 7.2 and a high thickness ratio of 5.3 was obtained. It is proved that the biaxial spinning extrusion forming process is feasible and practical. The research results provide a theoretical basis for the spinning extrusion forming of thin-walled tubes with circumferential T-shaped ribs.

Key words: thin-walled tube with T ribs, biaxial spinning-extrusion forming, diameter expansion, numerical simulation

CLC Number: