冲压焊接多级离心泵的理论研究及工程实现

›› 2005, Vol. 41 ›› Issue (2): 228-233.

• 论文 • 上一篇

扫码分享

冲压焊接多级离心泵的理论研究及工程实现

刘元义;蔡保元;霍春源;刘加利;王广业

山东理工大学教务处;上海理工大学动力工程学院;中国机械技术装备有限公司;山东理工大学机械工程学院

发布日期:2005-02-15

THEORETICAL STUDY AND ENGINEERING IMPLEMENTATION OF STAMPING AND WELDING MULTILEVEL CENTRIFUGAL PUMPS

Liu Yuanyi;Cai Baoyuan;Huo Chunyuan;Liu Jiali;Wang Guangye

Office of Educational Administration, Shandong University of Technology Department of Dynamic Engineering, University of Shanghai for Science and Technology China Mechanical Technical Equipment etc.

Published:2005-02-15

摘要/Abstract

摘要： 提出了把“理想流体”作为参照量，把粘性边界层作为水流动边界条件的粘性水力设计方法。针对冲压焊接多级离心泵吸入口的流态，推导出了粘性条件下的畸变方程式和输运方程式，以此应用于冲压焊接多级离心泵的水力设计，实践应用改善了冲压焊接多级离心泵的性能，提高了运行效率。

关键词: 冲压焊接多级离心泵, 工程实现, 理论研究

Abstract: This essay, by referring to the“ideal liquid”proposes the viscous hydraulic design methods under the conditions of water-moving border of viscous layer of border. The authors deduced viscous distortion equations and transport equations according to water entering conditions of the stamping and welding multilevel centrifugal pumps. This method is applied to the hydraulic design of the multilevel pumps and improved their functions and efficiency.

Key words: Stamping and welding multilevel centrifugal pumps, Theoretical study

中图分类号:

TH313

刘元义;蔡保元;霍春源;刘加利;王广业. 冲压焊接多级离心泵的理论研究及工程实现[J]. , 2005, 41(2): 228-233.

Liu Yuanyi;Cai Baoyuan;Huo Chunyuan;Liu Jiali;Wang Guangye. THEORETICAL STUDY AND ENGINEERING IMPLEMENTATION OF STAMPING AND WELDING MULTILEVEL CENTRIFUGAL PUMPS[J]. , 2005, 41(2): 228-233.

[1]	刘元义;王广业. 冲压焊接多级离心泵叶轮内部流场的计算机辅助分析[J]. , 2007, 43(8): 207-211.
[2]	朱祖超. 超低比转速高速离心泵的理论研究及工程实现[J]. , 2000, 36(4): 30-33.
[3]	朱祖超. 提高高速泵气蚀性能的理论分析与试验研究[J]. , 1999, 35(6): 85-88.

冲压焊接多级离心泵的理论研究及工程实现

THEORETICAL STUDY AND ENGINEERING IMPLEMENTATION OF STAMPING AND WELDING MULTILEVEL CENTRIFUGAL PUMPS

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 3

编辑推荐

Metrics

本文评价