超高速铣削的理论研究

›› 2001, Vol. 37 ›› Issue (3): 109-112.

• 论文 • 上一篇

扫码分享

超高速铣削的理论研究

梁锡昌;郑小光;徐国斌

重庆大学机械传动国家重点实验室

发布日期:2001-03-15

THEORY ON SUPER HIGH-SPEED MILLING

Liang Xichang;Zheng Xiaoguang;Xu Guobin

Chongqing University

Published:2001-03-15

摘要/Abstract

摘要： 多年研究表明，利用现有的切削理论，已经无法再成十倍的提高切削速度。一种新的超高速铣削理论被提出，它的思想是：一方面利用挤压变形和摩擦，提高工件切削区的温度，使工件的强度和硬度显著下降；另一方面，设法保持刀具的温度在300℃以下，使硬度不变；从而实现了刀具硬度与工件硬度比的大量增加，实现了vc＝8500m/min超高速铣削。本理论已经生产验证，表明本理论的正确性。

关键词: 超高速切削, 超高速铣削

Abstract: The research indicates it is impossible that cutting speed is improved decuple in accordance with present cutting theory. A new theory on super high-speed milling is put for-ward, in milling machining, the temperature of cutting zone increases as a result of distortion and friction, strength and hardness descend prominently. On the other hand, the temperature of cutting tool is kept under 300℃ and the hardness is invariable, so the ratio of cutting tool and workpiece hardness increases and super high-speed (vc=8500m/min) milling is achieved. The theory has already been proved reasonable.

Key words: Super high-speed cutting, Super high-speed milling

中图分类号:

TG618

梁锡昌;郑小光;徐国斌. 超高速铣削的理论研究[J]. , 2001, 37(3): 109-112.

Liang Xichang;Zheng Xiaoguang;Xu Guobin. THEORY ON SUPER HIGH-SPEED MILLING[J]. , 2001, 37(3): 109-112.

[1]	王素玉;于涛;孙景友. 径向剃齿刀在机修磨原理解析计算[J]. , 2005, 41(4): 163-167.
[2]	吕明;梁锡昌;郑晓华;陈志京. 刀齿与轮齿变形对剃齿误差的影响[J]. , 2000, 36(5): 76-80.

超高速铣削的理论研究

THEORY ON SUPER HIGH-SPEED MILLING

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 2

编辑推荐

Metrics

本文评价