• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (17): 463-472.doi: 10.3901/JME.260919

Previous Articles    

Study on Taper Angles for Through Holes Machined by Using Picosecond Laser Spiral Layer Micro Cutting Combined with Backside Reflection and Refocusing

LI Rui, WANG Houxiao   

  1. Shandong Provincial Key Laboratory of High Performance Precision Manufacturing and Hybrid Machining, Shandong University of Technology, Zibo 255000
  • Received:2025-09-14 Revised:2025-12-29 Published:2026-11-20

Abstract: A novel method, which is called the picosecond laser spiral layer micro cutting combined with backside reflection and refocusing, is proposed and utilized to solve the problems in terms of small hole depth and tapered hole, which usually occur during the process of ultrafast laser hole machining. The effect of the backside picosecond laser spiral layer cutting using a reflected and refocused laser beam on the hole exit enlargement, the taper angle reduction, the hole cutting efficiency and the hole wall improvement is accordingly explored with mechanism analysis based on the analysis for the influence of the transient cutting layer defocus distance and the axial layer feed distance of the picosecond laser focal spot on the machined hole depth and diameter. It is found that the peak hole depth is machined by using picosecond laser spiral layer cutting when the defocus distance of the laser focal spot is defined as zero referencing to each transient cutting layer. As compared to the single-layer picosecond laser spiral cutting, the hole depth is notably increased by using the multi-layer picosecond laser spiral cutting. Furthermore, the through-hole exit is notably enlarged together with an effective improvement for the hole cutting efficiency while the through-hole taper angle is greatly reduced by using this newly proposed method. In addition, when applying the method proposed, the hole wall morphology near the through-hole exit is improved notably, and the hole taper angle is further reduced effectively by increasing the feed distance for laser spiral layer cutting.

Key words: picosecond laser, spiral layer micro cutting, backside reflection and refocusing, micro hole, taper angle

CLC Number: