• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (18): 157-168.doi: 10.3901/JME.260778

Previous Articles    

Multi-scale Large Time-Series Model for Tool Condition Monitoring in Precision Boring of Airplane Intersection Hole

YANG Zhanpeng1,2, HUA Feng3, XU Yunhao4, ZHAO Pengyuan1, WANG Yingjun2, SONG Haitao5, CHENG Cheng1,2   

  1. (1. School of Artificial Intelligence and Automation, Huazhong University of Science and Technology, Wuhan 430074;
    2. National Center (Sichuan) of Technology Innovation for Advanced Aviation Equipment Corporation, Chengdu 610000;
    3. School of Mechanical Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074;
    4. Applied Mathematics and Computational Sciences/Computer Science, Duke Kunshan University, Kunshan 215316;
    5. Shanghai Artificial Intelligence Research Institute, Shanghai 201100
  • Received:2025-11-02 Revised:2026-05-31 Published:2026-11-20

Abstract: The machining quality of intersection holes is directly related to the structural performance and fatigue life of airplane. The boring process involves a multi-body coupling of the machine, tool, workpiece, and fixture, where the system state exhibits strong dynamic time-varying characteristics, resulting in significant distribution shifts in monitoring signals among different tools. Conventional end-to-end models, limited by the specific distribution of training data, struggle to accurately generalize to the full life-cycle state of new tools. To address this, a tool condition monitoring method based on a multi-scale time-series large model is proposed. Rotary Position Embedding and multi-scale attention mechanisms are introduced to construct a general representation learning architecture for high-frequency non-stationary cutting signals. An "unsupervised pre-training and few-shot fine-tuning" paradigm is adopted, utilizing massive unlabeled data to learn intrinsic signal features and achieving rapid adaptation to downstream monitoring tasks via limited labeled samples. Validation is conducted on a three-axis CNC boring platform for intersecting holes. Experimental results indicate that the proposed method significantly outperforms traditional deep learning models in terms of prediction accuracy and robustness. The prediction errors for flank wear width, measured by Mean Absolute Error and Root Mean Square Error, are controlled within 3μm. The effectiveness and application potential of the time-series large model in intelligent operation and maintenance tasks for high-end equipment are thus verified.

Key words: tool condition monitoring, boring process, large time series model

CLC Number: