• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (18): 339-347.doi: 10.3901/JME.260630

Previous Articles    

Correlation between the Ductile Brittle Transition Behavior and the Coordinated Deformation of Adjacent Grains of Cr-Mo-V Steel Weld Metal

DOU Guishan1, CAO Rui1, QIAO Xiaoli2, JIANG Yong3, LI Yimin2, TAO Yanwen2, ZHANG Kejing3, LI Jinmei4, WANG Cen2, LIN Qiaoli1   

  1. 1. Department of Materials Science and Engineering, Lanzhou University of Technology, Lanzhou 730050;
    2. Lanzhou Ls Heavy Equipment Co., Ltd., Lanzhou 730050;
    3. Sichuan Atlantic Welding Materials Co., Ltd., Zigong 643000;
    4. Lanzhou Ls Testing Technology Co., Ltd., Lanzhou 730050
  • Received:2025-12-03 Revised:2026-05-15 Published:2026-11-20

Abstract: 2.25Cr1Mo0.25V steel is widely used in hydrogenation equipment and high-temperature, high-pressure pipelines due to its excellent high-temperature performance, tempering resistance, and high-temperature durability. However, its weld metal during welding is prone to issues such as uneven microstructure and high brittle ductile transition temperature, which can directly affect the safety and reliability of welded structural components under low-temperature or variable-load conditions. Therefore, in-depth research on the microstructure control and toughness improvement mechanisms of its weld metal is of great significance for the long-term stable operation of this material in large-scale equipment. The microstructure of three weld metal (as-welded (AW) and two post-weld heat treatments(PWHT) (705 ℃×8 h, PWHT.MIN) and 705 ℃×32 h, PWHT.MAX)) is characterized by scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD). And the impact toughness of the weld metal is measured through the standard Charpy V-notch impact experiments in high/low temperature environments. The results indicate that the microstructure of AW specimen primarily consists of blocky ferrite and granular bainite, exhibiting microstructure inhomogeneity and incoordination of deformation between grains, and the impact energy at 25 ℃ is less than 10 J; while after holding at 200 ℃ for 20 minutes, ferrite appears in the microstructure, and the impact energy reaches 90 J. After post-weld heat treatment, the microstructure is composed of ferrite, and the impact energy at 25 ℃ is increased to 200 J. The brittle ductile transition temperatures of the AW, PWHT.MIN, and PWHT.MAX specimens are 158 ℃, -30 ℃, and -40 ℃, respectively. As tempering time increases, the degree of coordinated deformation between grains improves, crack nucleation is delayed, and the resistance to crack propagation is enhanced, leading to a significant reduction in the brittle ductile transition temperature.

Key words: 2.25Cr-1Mo-0.25V steel weld metals, post weld heat treatment, low-temperature impact toughness, high-temperature impact toughness, ductile-to-brittle transition temperature

CLC Number: