• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (17): 309-321.doi: 10.3901/JME.260916

Previous Articles    

Geometric Error Modeling and Iterative Compensation Method of Internal Gear Power Honing Machine

ZHANG You, LI Congbo, CAO Huajun, TAO Guibao   

  1. State Key Laboratory of Mechanical Transmission for Advanced Equipment, Chongqing University, Chongqing 400044
  • Received:2024-11-25 Revised:2025-02-26 Published:2026-11-20

Abstract: The internal gear power honing process produces a special tooth surface texture that effectively reduces mesh noise, and is widely used in the gear machining of electric drive transmission systems for electric vehicles. The internal gear power honing process involves multi-axis linkage and complex tool trajectory. There are a large number of geometric errors and complex coupling mechanism, which has a significant impact on machining accuracy. To improve the machining accuracy of gear honing, a geometric error modeling and iterative compensation method for internal gear power honing machine is proposed. Firstly, the transmission mechanism of geometric errors of internal gear power honing machine under multi-axis coupling is systematically analyzed, and the geometric error model is established. Then, the mapping model of geometric error and workpiece tooth surface deviation is constructed. The crucial geometric errors affecting tooth surface deviation are identified by sensitivity analysis, and an iterative compensation strategy for crucial geometric errors is proposed. Finally, the effectiveness and practicability of the proposed method are verified by case analysis and compensation method comparison.

Key words: geometric error modeling, iterative compensation, internal gear power honing, sensitivity analysis

CLC Number: