• CN: 11-2187/TH
  • ISSN: 0577-6686

Journal of Mechanical Engineering ›› 2026, Vol. 62 ›› Issue (16): 179-195.doi: 10.3901/JME.260864

Previous Articles    

Numerical Simulation Study on Aerodynamic Loads during the Operation of Power-concentrated EMUs in Small-section Tunnels on the Longhai Line

HUANG Zundi1, LIU Xiyu1, LIU Rongyuan1, CHANG Ning1, LING Liang2   

  1. 1. School of Rail Transportation, Wuyi University, Jiangmen 529000;
    2. State Key Laboratory of Rail Transit Vehicle System, Southwest Jiaotong University, Chengdu 610031
  • Received:2025-08-04 Revised:2026-03-05 Published:2026-10-14

Abstract: When power-concentrated EMUs pass through single-track small-section tunnels on the Longhai Line, aerodynamic loads and instantaneous pressure changes threaten the safety of train operation and the comfort of passengers. The study conducted numerical analysis on this aerodynamic characteristic. By using aerodynamic simulation and sliding mesh technology, the aerodynamic load and surface pressure changes of 9-carriage EMUs at different speeds are studied, and the influences of speed and tunnel length on parameters such as lateral force, drag and lift are discussed from the time domain and frequency domain. The results show that the higher the train speed, the greater the lateral force. The lateral forces of the lead vehicle and the middle vehicle are relatively small, while the rear vehicle is most significantly affected by the air vortex, which can account for more than 60% of the entire vehicle and plays a dominant role in the overall lateral force. The most unfavorable tunnel length decreases as the speed increases, and the lateral force amplitude of the rear vehicle can reach 600%. If the aerodynamic lateral force acts continuously for a long time, it may affect the stability of the track and cause the rear vehicle to sway. When a train runs in a tunnel, the positive pressure decreases and the negative pressure increases. The pressure at the entrance and exit of the rear vehicle is asymmetrical. Affected by the tail vortex, the pressure difference on both sides is 87 to 375 Pa. Under normal conditions, the aerodynamic resistance of the lead vehicle is approximately four times that of the rear vehicle. In the most unfavorable tunnel, the resistance rises rapidly upon entry and then fluctuates. The leading vehicle experiences increased drag due to compression waves and decreased drag due to expansion waves, while the middle vehicle changes relatively little. The pattern for the rear vehicle is the opposite. When the train enters and exits the tunnel, the lift fluctuates significantly. When the speed increases from 120 km/h to 160 km/h, the lift increase can reach 200%, and the peak value intensifies with the increase of the tunnel length. The lift of the three-car accounts for 58% of the total vehicle and is the most sensitive to changes in speed. The research results provide technical support for enhancing the safety and comfort of train operation and ensuring the efficient and stable operation of the Longhai Railway.

Key words: powered carriage train set, tunnel, pneumatic load, numerical simulation

CLC Number: